Simple Tips to Help You Save Money on Your Plumbing in Clearlake, CA
Tip 1: Know How and When to Shut Off the Main Water Valve
It is essential that each person in your home knows how and when to turn off the main water valve. If there is a severe leak, broken pipe or other problem involving uncontrolled flooding, quickly turning off water flow is vital. The main shut off valve is usually located on the side of the home, the street curb or in the garage. If you are not sure of its location, contact your local water provider.
Tip 2: Check for Leaks
You may be familiar with dripping coming from faucets. Although it may test your sanity, it may be an indication of other potential leaks. Examine your toilet and pipes to see if there is any excess water going out. This can potentially save you hundreds of dollars on your water bill.
Tip 3: Turn Your Taps Off
Many individuals forget to ensure their taps are shut off completely. Though dripping may appear seemingly small, you can waste up to 15 gallons of water a day. Save money by checking to be sure your taps are turned off completely.
Tip 4: Ensure Toilets Flush Properly
If the handle must be held down for a thorough flush or juggled to stop water from running, consider replacing the worn out tank parts. Most of these components are inexpensive and you definitely notice a decrease in your water bill.
Tips on How to Save Money on Your Drains and Sewers in Clearlake, CA
Tip 1: Clear Your Drains
It is important to check your drains and make sure they are cleared. This will help to stop backlog of water which can lead to flooding. Install a backflow valve in the floor drain if you reside in an area where sewers sometimes back up into homes. This device helps to prevent future backups.
Tips 2: Use Hot Water to Clean Infrequently Used Drains
Pour a gallon of water into infrequently used drains to fill the trap and prevent unpleasant smells from entering the house. Snake slow floor drains to ensure they carry away water quickly in the event of a flood.
Tip 3: Keep Hair Out of the Bathroom Sink and Shower
While it is common for the toilet, shower and bathroom sink to get blocked; there are numerous things that can be done to minimize clogs in these areas. First, is to prevent hair from going down the drain by installing a drain strainer over the opening. Second, avoid using your toilet as a garbage can. Do not put the following items in your toilet toys, cotton balls or facial wipes, cotton swabs, sanitary towels and baby wipes.
3 Tips on How to Save Money on Water Heaters in Clearlake, CA
Tip 1: Replace Inefficient and Outdated Heaters
Consider replacing water heaters that are more than 15 years old. Newer water heaters are more energy efficient.
Tip 2: Install Heat Traps on Your Water Heater Tank
Installing heat traps on your water heater tank allows you to save $15 to $ 30 on your water heating bill. You need to hire a qualified plumber to help you install them on an existing tank. However, some newer storage tanks have readily installed heat traps.
Tip 3: Take Short Showers Instead of Baths
Your savings largely depend on you and your family’s habits. A long hot shower may use lots of hot water than a bath where the tub is not filled to the brim. But also a bath can use with only inches of water can costly, especially if you have those huge-jetted baths. To save money, it is advisable to take short showers.
Tips on How to Save on Tankless Water Heaters in Clearlake, CA
Tip 1: Use Less Hot Water
One sure way of cutting hot water costs is using less of it. Installing low-flow showerheads and faucet aerators will allow you to cut your hot consumption by 25 to 60 percent. Plus, you will save on your water bills.
Tip 2: Drain the Sediment
Water heater storage tanks accumulate sediments which reduce efficiency and make saving energy a challenge. Removing sediments from your tank will keep it operating optimally.
Tip 3: Insulate Exposed Hot Water Pipes
If you insulate your hot water pipes, waters will reach your faucets two to four degrees warmer. This means you will not have to wait for it to heat up, thus saving energy, water.
Tips on How to Save on Septic Systems in Clearlake, CA
Tip 1: Do Not Flush Certain Items
Avoid flushing items, such as bandages, feminine products, baby wipes, disposable diapers, paper towels, cigarette butts, cooking oils and fats into your septic system. This will help you to avoid major clogs, which may be expensive to fix.
Tip 2: Keep Tress and Plants Away from the Drainfield
Another way to save money and avoid costly repairs is to keep your trees and plants planted away from your septic system. Roots from nearby plants and trees can find way into pipes, distribution boxes and other components leading to clogs and pipe breakages.
Tip 3: Schedule Routine Septic Inspection
For a long-lasting septic system, perform regular maintenance and septic tank pumping every 3 to 5 years on average.
How to Save Money on Systems for Water Treatment in Clearlake, CA
The cost of water is steadily rising. Installing a water treatment system will help you reduce your water bills. First, when you clean anything from kitchenware to living room floor, you use a lot of soap or detergent. This is because you use hard water. Water purification systems soften hard water allowing you to use much less soap and detergent. Another way to save money on your water treatment system is to schedule routine inspection and maintenance with a qualified plumber. Regular maintenance ensures minor issues are caught early before they become too costly to repair.
With an adequate understanding of the above tips, you will certainly save money on your Plumbing in Clearlake, CA. For optimal performance, only qualified plumbing contractors to inspect, maintain or repair your plumbing system.
