Maintenance Checklist for Your Plumbing in Hidden Valley, CA
Examine Fixtures for Leaks and Damages
Fixtures like showers and toilets should be inspected for any damages or leas. Though your fixtures may be working well despite obvious wear and tear, any significant dents, cracks and corrosion are positively a major concern. Any damage may cause a serious interruption on the performance of the fixture. Remember to check for any, which can be identified through damp ceilings, wet walls or damp spots on floors.
Inspect Faucets for Leaks
According to the United States Environmental Protection Agency, a faucet dripping at a drip per second will cost you over 3,000 gallons of water a year. Do not just ignore faucet leaks as a minor problem. They may be caused by a problem with a faucet’s washer or seals. If you want to reduce your water bills significantly, you have to ensure you are inspecting your faucets closely and call for repairs as soon as possible.
Perform Flush Tests on Toilets
Test-flushing allows you to determine whether there are any issues with the fixture that will require calling for repairs before it is too late. If your toilet performs “phantom” flushes or runs continuously, it could be a problem, perhaps a broken seal that needs replacement.
Test for Proper System Pressure
Your plumbing must sustain a certain water pressure to function smoothly. This pressure is a measure of force with which water exits shower and faucet hardware. Low water pressure may be indicate the accumulation of sediments near these exit points and may also be a sign of water line problems.
Check for Corrosion
Corrosion in pipes can cause leaks and hamper proper connections. Check for green stains near valves and fitting connections used to shut off flow.
Maintenance Checklist for Your Drains and Sewers in Hidden Valley, CA
Keep Drains Clear
Spend a little time on drain cleaning will help prevent leaks and structural damage in the bathroom and kitchen. Remove hair and other debris from shower and sink drains using your hands or drain snake. Use natural solutions if you notice drains are slower than usual.
Inspect Each Sink Drain, Stand-up Shower and Bathtub
If any of these are slower, there may be a stymied vent pipe or a clog. The appearance of bubbles during drainage may also indicate a problem. Clean out the p-traps under your sink to prevent future clogs.
Look out for Slow Drainage
Slow draining toilets and sinks may be an indication that a major clot is coming. The slow drainage can be due to a minor clog that be removed easily. But, if your plunger does not work, you should contact a plumbing contractor who can provide drain snaking services.
Maintenance Checklist for Water Heaters in Hidden Valley, CA
Examine Your Water Heater for Leaks
If you have been noticing damp spots or puddles on your water heater, then chances are that you have a leaking water heater tank. The longer you allow the leak to persist, the worse it becomes for your savings. Contact your water heater repair expert if you notice any visible signs of water heater leaks.
Manage Hot Water Temperature
According to the US Environmental Protection Agency, turning down the temperature of your water heater by a few degrees can save up to 10 percent on energy bills annually. Turning down the temperature also helps to prevent water from scalding.
Inspect the Temperature and Pressure Relief Valve
The Temperature and Pressure relief valve on your water heater should be examined annually for proper operation. Sometimes, they are too worn out and won’t re-seal after testing them out. Thus, be prepared to replace them for efficient operation.
Maintenance Checklist for Tankless Water Heaters in Hidden Valley, CA
Flush Out Your Water Heater
You should drain your tankless water heater to remove any sediment that may have accumulated Sediment causes corrosion, shortens your unit’s life span and reduces its efficiency.
Examine Water Heater’s Interior
Flakes of rust indicate a problem. Check to be sure that your burner flame is blue not yellow. If you see a yellow flame, clean out the unit’s jets.
Maintain your tankless water heater temperature setting at 120 degrees Fahrenheit for maximum performance.
Maintenance Checklist for Water Treatment Systems in Hidden Valley, CA
Test Your Water Regularly
To determine whether your water treatment system in functioning properly, you should test your water regularly. Test the water for bacterial quality every six months and chemical quality every two years. Test both treated water and untreated water, and then compare the results.
Keep it Clean
For optimal performance, keep all parts of your water treatment system clean by replacing spent cartridges, pre-filters, adsorption media and air filters. Clean the main storage tank if used and maintain the fan motors and re-pressurization pumps.
Maintenance Checklist for Septic Systems in Hidden Valley, CA
Pump Out the System Regularly
For optimal system, pump out your system when needed. Avoid using strong chemicals and bacteria destroying compounds, such as paints, solvents, drain cleaners, pesticides, motor oil and sink cleaners. These may damage the septic and disrupt absorption system operation.
Keep Records
It is vital to keep a detailed record of all inspections, pumping and other maintenance practices done to your system along with a sketch of where the septic system is located.
Conserve Water
Inspect the system for damaged toilet tank valves, fix leaky components and install appliances and fixtures that use less water and avoid wasteful practices.
Routine Inspection
Regularly inspect the septic system and maintain any effluent alarms and pumps that make up the system.
With routine maintenance, your home’s plumbing in Hidden Valley, CA will keep functioning optimally all year round. Use the maintenance checklist above to check for things you can fix on your own or to know when to contact a professional before minor issues become too complex and expensive to handle.